Professional solar panel mesh installation using 304 grade stainless steel and a non-penetrative clip system that protects your panels, preserves your roof, and keeps birds out permanently.
Most installers use galvanised wire mesh. It's cheap and it oxidises within 2–3 years in Brisbane's climate, leaving rust stains on your roof and an ineffective barrier. Some use aluminium — better, but still prone to deformation over time.
We use 304 grade stainless steel exclusively. It's the same specification used in marine and food-industry applications — engineered for corrosion resistance, UV stability, and 10+ years of performance without degradation.
Many installers drill through roof tiles or screw into flashings to anchor their mesh. This creates entry points for water, voids roofing warranties, and risks tile cracking on terracotta or concrete roofs.
Our clip system attaches exclusively to the panel frame — the aluminium rail that surrounds each panel. No drilling, no penetrations, no contact with your roof surface. The installation can be fully reversed without leaving any trace.
Every installation follows the same proven process. Most residential jobs are completed in a single 2–4 hour visit.
We quote based on your panel count and roof layout — $23 per linear metre of perimeter. No inspection fee, no variable day-of pricing.
All nesting material, eggs, droppings, and debris are removed from the full panel area. The space is cleared and prepared before any mesh is cut.
Mesh is measured and cut on-site to fit your exact panel configuration. Every corner, junction, and edge is accounted for — no gaps, no shortcuts.
Mesh is secured to panel frames using UV-stable non-penetrative clips at regular intervals around the full perimeter. The result is a tight, tamper-resistant barrier.
We inspect the completed installation from all angles, then send you a full photo and video report of the work done — whether you were home or not.
A single gap is all pigeons need to re-establish a nest. We measure and cut each piece individually — standard roll installations leave gaps at corners and cable entry points.
Drilling into tiles or screwing into flashings introduces water ingress risk and voids your roofing warranty. Our clip system never touches the roof surface.
Galvanised mesh rusts in 2–3 years in Brisbane's subtropical climate. 304 stainless steel is the correct specification for coastal, humid, and high-UV environments.
No. Our clip system attaches only to the panel frame — not the panel itself. Solar manufacturer warranties are tied to the panel components, not accessories attached to the frame. Your warranty remains fully intact.
Most residential installations are completed in 2–4 hours. Larger commercial systems or complex multi-array roofs may take a full day. We give you a time estimate with your quote.
Yes. The clip system is fully reversible — mesh sections can be removed by a technician and reinstalled after servicing is complete. We can also attend for panel-access removals if needed.
Minimal. We recommend a visual inspection every 12 months — this is typically combined with your annual solar panel clean. The mesh itself requires no special care. To keep your 10-year warranty valid, panels should be cleaned every 24 months.
$23/m. No drilling. 10-year warranty. Same-day quote.
